Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
- 10. Body
10.1. Maintenance and repair
10.2. Vinyl finishing
10.3. Upholstery and rugs
10.4. Repair of insignificant damages
10.5. Repair of considerable damages
10.6. Loops and locks
10.7. Windshield and motionless glasses
10.9. Latch of a cowl and cable of the drive
10:10. Forward lattice
10:11. Forward wing
10:12. Internal panel of a door
10:13. Door lock, switch of the lock and handle
10:14. Door glass
10:15. Window regulator
10:16. Side mirrors
10:18. Door of a back compartment
10:19. Back cover (top door of a back compartment)
10:20. Casing of a steering column
10:21. Panels of forward facing of salon
10:22. Average floor section
10:23. Forward facing panel of salon
+ 11. Electric equipment
+ 12. Electrical circuitries
Works are performed together.
Removal and installation
| PERFORMANCE ORDER
| 1. Lift a door of a back compartment and remove the internal decorative panel of a door.
| 2. Disconnect all sockets of a door.
| 3. Cover the lower part of an aperture with rags.
||4. Disconnect levers of a door of a back compartment while the assistant supports a door. The bolt of fastening of the lever of a door of a back compartment is specified by an arrow.
||5. Before an otvorachivaniye of bolts of fastening of a door of a back compartment (are specified by shooters) outline contours of loops. Turn off bolts of fastening of loops to a door of a back compartment and remove a door.
|6. Installation is carried out upside-down.
| PERFORMANCE ORDER
| 1. Adjustment of a door of a back compartment concerning a body is reached by movement of a door at the released bolts of fastening of loops to a body or to a door. The door is considered adjusted if the top edge is parallel to an edge of the back panel. If adjustment of a door is not reached by movement in loops, then between loops and a body (door) it is necessary to lay remote laying (are available on sale).
| 2. For adjustment of provision of the closed door be convinced that the latch of the lock makes contact with the central part of a clamp. Otherwise adjust, moving a clamp up-down.
||3. Adjust gearing of a latch with a clamp and the provision of a door, moving a clamp up-down, or back and forth.
On the homepage